Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
howtos:setup:gigaset_n300_n510 [2018/08/13 16:27]
vkaup [Further Reading] amend link to gigaset.com
howtos:setup:gigaset_n300_n510 [2019/09/09 15:59] (current)
sfalconer [Configuration]
Line 20: Line 20:
     * **Authentication Password** will be the SIP password as provided in your Welcome Pack     * **Authentication Password** will be the SIP password as provided in your Welcome Pack
     * **Username** will be the same as //​Authentication Name//     * **Username** will be the same as //​Authentication Name//
-    * **Display Name** can be anything meaningful to you. We suggest the name of the person using this handset as this will appear on called extensions.+    * **Display Name** can be anything meaningful to you. We suggest the name of the person using this handset as this will appear on called extensions.{{ :​howtos:​setup:​screenshot_from_2019-09-09_14-54-23.png?​nolink&​1000 |}}
   - Click the **Show Advanced Settings** button   - Click the **Show Advanced Settings** button
   - Under **General Provider Data** enter the following:   - Under **General Provider Data** enter the following:
Line 29: Line 29:
     * **Stun enabled** should be set to **No**     * **Stun enabled** should be set to **No**
     * **NAT refresh time** should be **30** sec - you may need to adjust this depending on your particular router/​firewall     * **NAT refresh time** should be **30** sec - you may need to adjust this depending on your particular router/​firewall
-    * **Outbound proxy mode** should be **Never**+    * **Outbound proxy mode** should be **Never**{{ :​howtos:​setup:​screenshot_from_2019-09-09_14-55-24.png?​nolink&​1000 |}}
   - Click the **Set** button   - Click the **Set** button
   - Reboot your base station   - Reboot your base station